|
|
Post by dinorocks on Oct 16, 2014 13:45:24 GMT -5
I needed a new pinch pan for my #4 DLS and decided to try one of the Paws-I-Trip pans but not sure exactly how it is to be installed to my trap. Any help would be appreciated...see below for some picts I took. Thanks, Dino     |
|
|
|
Post by camohoyt340 on Oct 16, 2014 14:29:27 GMT -5
It goes exactly the way you have it in the second picture. Take a hammer and bend the rectangular tabs around the frame. Then take a small punch and bend the little tab up into the hump on the frame. That holds it in place. I have some and love them.
|
|
|
|
Post by camohoyt340 on Oct 16, 2014 14:33:49 GMT -5
Actually now that I think of it, what I did was use a hammer to start the bending of the rectangular tabs. Once the bend was started I used a pair of vice grips and finished bending them.
I installed them on #3 dbls. So I guess I could be wrong. But I'm pretty sure those will go on the same way.
|
|
|
|
Post by dinorocks on Oct 16, 2014 15:07:02 GMT -5
Thank you very much! I'll give it a try and let you know how it went.
|
|
|
|
Post by nightstalker1 on Oct 16, 2014 19:18:59 GMT -5
Here are some pics of a finished install The tack welds are not necessary but a nice option    |
|
